Short AR Mag Pouch V1.1 (REMIX) by Qwerm

A remix of FecalDisco's "3D printable molle universal rifle magazine pouch" that is shorter, allowing it to hold 10 and 20rnd AR15 magazines. The MOLLE attachment was also replaced by a belt hook from PhilPhisher's "PPDS Ghoulster".

V1.1:
-Increased mag retention.
-Slightly easier mag insertion.
-Moved the cord lock to the front to make it easier to attach the pouch to your belt.
-Uses the same unmodified belt hook from the PPDS Ghoulster.

Print orientation: Print everything on it's side.

Settings used:
Material: PLA+
Extruder Temp: 210c
Bed Temp: 60c
Layer Height: 0.2mm
Wall Line Count: 5
Infill Percentage: 100%
Support: None

Materials Needed:
1/8 Inch Shock Cord
Cord Lock
2x M5x8 Screws
2x M5 Nuts