simple Tablet holder
Boost
11
19
23
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Boost
11
19
23
0
135
180
Released
Description
Simple Tabletholder.
Support under the Bridge is required (Tree small)
also check out my new version that can be printed without support:
Comment & Rating (23)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Praktikus, nagyon szeretem!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Looks and work very good!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Prints well, but the resulting tablet angle is a little low for my use case. It's probably fine on a desk.
The designer has replied
0
Reply
Hi,
as a tip for your use case, you could scale in one direction (asymmetrically) in the slicer so that the angle becomes steeper
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Loved this design. Thanks for sharing with the 3D printing world!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
all fine thanks
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Smooth and easy
0
Reply
Very Good!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld