Ford Model T Kit Card Shared by trevorwright06

Honzal

Shared by

Toys & Games>Puzzles

Print Profile(2)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill

44 min

1 plate

3.5(13)

0.2mm layer, 2 walls, 15% infill

46 min

1 plate

5.0(4)

Boost

131

252

135

Released

Description

This is a little kit card I found on Printables that I like. It is a challenge to put together, and there is a possibility that you will break your fingers. The end result is very cool.

Comment & Rating (20)

@user_3263155962

Very nice design! It's actually not that hard to assemble, I don't think a guide is necessary, just need to be more patient and be careful. Some holes could be larger as it's hard to slide in the pins. Suggest print with softer material. I used Polymaker's PolyTerra, which is not that easy to break. Overall, a very nice print!

@msimpson

This is not a card kit. It does not have a frame to hold all the parts intact.

@Moragalorian

Print Profile

0.2mm layer, 3 walls, 15% infill

near impossible to actually put together

@TechDaddyK

Print Profile

0.2mm layer, 3 walls, 15% infill

Very difficult to assemble. Instructions would help.

@bethlangley

Print Profile

0.2mm layer, 3 walls, 15% infill

It prints but would be better with a frame to hold parts

@ghostgirl

Print Profile

0.2mm layer, 3 walls, 15% infill

Well..the print profile is great! Zero issues printing and getting it off the plate. Was even able to print two colors of it in under and hour and a half. Bad news is the only thing I’ve assembled so far is a steering wheel, lol. If you know of any directions for how this thing fits together, lemme know! :D

@Sethi84_P1S

Print Profile

0.2mm layer, 3 walls, 15% infill