So did not like the models that were designed so far to help fix the filament jamming / poop jamming on X1 Carbons since they were just pressure fitted and got weak in the heated chamber and then tend to get knocked off or unaligned.
So, i designed this one to be keyed into the shaft to lock into place and weighted as well. Also it comes to the top of the container as it should be. Also a small wedge on one of the legs to make sure the lower metal is always pushed forward properly vs the other designs which allowed it to swivel into different angles.
Print vertically and add custom support to the one leg only the rest prints just fine. I print it solid but you can use standard 15% infill and standard settings.
When installing it clicks into and firmly locks it into place.