I did not like the original print when I used auto orient and printed it without supports.
This model eliminates the need for using supports and makes it easier to print. Uses common m3x6mm screws to install.
Assembly Instructions:
- Just lay it flat and print without supports
- Cut the 4mmptfe tube to length to fit the inside
- Enlarge the ends of the PTFE with a Philips or allen key for easier screwing
- Use two m3x6mm (m3x4mm if works) screws to install the tube
-
Printing Instructions:
- Material: ABS or at least PETG for high temp and sturdiness
- Infill: 100%
- Supports: No
- Rafts: No
- Brim: No