Do you own a P1S or X-series printer that flings filament poop all over your floor? Is it positioned in a location where using the typical poop chute can be quite a hassle? Allow me to introduce the innovative Poop Drawer! This nifty addition directs any printer residue into a conveniently located drawer beneath your printer. All you have to do is slide out the drawerand dump out the poop. Easy peasy lemon squeazy. The Poop Drawer requires approximately 800g of filament and takes approximately 23 hours to complete the printing process. Glue is highly recommended on the main body pegs, and overlaping areas on the drawer.
Changelog:
1/8/2024 - Updated print profile, replaced chute with V2
1/9/2024 - Added drawer lid print profile