No Print Profile yet. Add one to earn points.
This box is used for mounting a 30x30 standard sized flight controller for use as a receiver for a Betaflight to USB PC Gaming device.
Mount the flight controller as you normally would in a stack (don't need to care about soft mounting since the gyro is not used). Use a glob of hot snot or other adhesive to stick the nano receiver in (XM/XM+/RXSR/Nano ELRS, etc..).
Once this is built configure the receiver in Betaflight like you would when setting up your quad. Go to the command line and type "set usb_hid_cdc = on", save, and you're set!
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
15%
Filament:Any PLA/PETG Any
Notes:
Use 3 perimeter walls.