No that is correct, I did not include the tail because it was half in and half out of the doghouse and just did not look right. There is something else going on though with your print. Almost looks like it was too hot printing and the black spot should look like the pic attached.

I printed and had the same issue. the problem is it causes a lot if unnecessary poops. I would have just redone it with the color all white had I caught this before printing. otherwise it came out really nice

I will check the file, but the file is the exact one I printed from. I haven’t used makerworld long, but do you know if sometimes models get messed up from uploading?

Very welcome, this was a fun one to make and glad you liked it!

You are very welcome and thank you for liking it enough to give out as a gift. That means a lot! Merry Chistmas!🎄

I'm not very good a using the cut tool and the print looked bad in the end would you mind making a remix without the wings?

Thanks Mike I appreciate it! I am used to printing parts, so this was my first attempt at a character on an FDM. I can see why resin printers are much better at these. I was thinking of splitting the model in half, but than there may have been an issue with the controller. The stepping on prints is what really bothers me. Unless you are using a reall small nozzle, small details on curved surfaces like this, just don’t come out well. It surprises they have not been able to come up with a software fix for stepping issues, but I guess that is just the nature of printing layers.