Raiser for Bambu Lab P1P AMS Holder
Copyright Claim
Raiser for Bambu Lab P1P AMS Holder
Boost
6
12
10
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
3 h
1 plate
20 min faster - not tested - 0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Boost
6
12
10
0
54
24
Released
Description
This is a very simple model that elevates the original AMS Bambu Lab holder.
I created it because I printed the holder from the BambuLab website and it turned out that the extruder cable rubs against the bottom of the AMS. I didn't want to waste the material and print the whole new holder - so my idea is to glue the raiser.
You need to print 2 identical raisers vertically preferably using brim, 0,2 layer height, 3 wall loops and 15% infill.
Assembly consists in gluing the holder to the raiser using ordinary CA glue :)
Comment & Rating (10)
All
Good solution, with all this "risers" u can dowload everyone think i got chain installed, so nothing fits on top without chain.... good work
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
good but not a long term solution
0
Reply
Never mind
0
Reply
How do they connect to the the AMS?
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Other Issues: These are not the right ones. If you use them, the AMS might collapse.
The designer has replied
0
Reply
Please read the model description - "I didn't want to waste the material and print the whole new holder - so my idea is to glue the raiser."
- "Assembly consists in gluing the holder to the raiser using ordinary CA glue :)"
This is a model that attaches to the original bambu riser by glue. Please change your rating as it has been rated incorrectly.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld