OLI - the little Ocean Liner
Copyright Claim
OLI - the little Ocean Liner
Boost
45
60
11
Print Profile(3)
0.08mm layer, 2 walls, 15% infill
2.9 h
1 plate
0.2mm layer, 2 walls, 15% infill
1.7 h
1 plate
0.2mm layer, 2 walls, 15% infill
1.1 h
1 plate
Boost
45
60
11
0
143
53
Released
Description
Oli is a small steamer that invites the passengers to an excursion in the bathtub.
The new access to my bathtub boat collection is once again a very easy to print but above all robust boat, which hopefully withstands the stresses in play.
Nevertheless, you should always be careful that children do not put this toy in their mouths.
Comment & Rating (11)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed well, but the ship don't float correctly in water, I think the bottom öayers need to have stronger infill to make them heavier.
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
problème d’encollage, je n’ai pas la bonne colle
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
a nice product
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Floats like it says.
0
Reply
cute design.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld