I have a P1P with the ARC enclosure, and I wanted a place to fit my twin set of Anycubic Air Purifiers to reduce the VOC levels while printing ABS/ASA, so I designed this raiser to allow fitting the air purifiers on top (for maximum extraction), while still maintaining the printer's good looks, and avoiding high angles of the PTFE which could cause extrusion problems.

This was made to work seaminglessly (locking tabs) with the ARC enclosure, but the dimensions will work also with any round shaped P1P enclosure or the original X1C enclosure!

This will make the top glass sit 62mm above the original place, which should also solve a lot of the PTFE tube angle problems that some people are having (With the top glass, the PTFE gets a too hard angle, creating extrusion problems).

Provided is the .3MF project with the top being printed in 2 plates. Additionally you should also print the locking tabs (to lock the pieces together) and use a M3 screw and M3 brass inserts. It uses the same dimensions brass inserts and screws than ARC project.

For the X1 / X1C users, you just need to download the riser.

INFO: CAN BE PRINTED WITHOUT SUPPORTS!