Simple Tape Rack - Holder - Organiser for various tape rolls
Copyright Claim
Simple Tape Rack - Holder - Organiser for various tape rolls
Boost
28
54
7
Print Profile(1)
0.24mm layer, 2 walls, 15% infill
Designer
12 h
4 plates
Boost
28
54
7
0
57
59
Released
Description
That is a simple to print and assembly (just push the parts in) Roller tape rack - Organiser .
I have also included a thicker middle part if you want to double the rack .
if you want to make a double rack just print the plates :
“Middle Parts” x2
“Back Plate” x2
“Middle part for Double Rack” x1
Enjoy !
Comment & Rating (7)
All
Print Profile
0.24mm layer, 2 walls, 15% infill
Nearly perfect, but the tabs on the "Bottom Part" required sanding to fit. Since all the other pieces snapped together flawlessly, I'd suggest adding a bit more clearance to those pieces, or adding a chamfer to the ends for a smooth fit.
The designer has replied
1
Reply
yeah you know with the fitting is a bit complicated and have to do also with filament or the flow ratio .. for me for example all the parts fits nice , I just hit them a bit with the plastic hammer and all fit good together .. but maybe like you suggest a fillet or chamfer will help.
Thanks for your feedback !!
(Edited)1
Reply
Replying to @KFDesigns
Yeah I tried a mallet but it was too stubborn haha. But seriously it's an awesome design, thanks for uploading!
0
Reply
Hats off to the creator for organizing all of the plates, settings, calibration lines. Had zero issues making this
5/5
(Edited)1
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.24mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld