Back to the Future Outatime Licence plate Lightbox
Back to the Future Outatime Licence plate Lightbox
Boost
105
150
9
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
5.7 h
2 plates
Boost
105
150
9
0
132
64
Released
Description
This is a licence plate Lightbox from the Movie Back to the Future.
The profile works OK with my settings but you must check and dial in your Printer accordingly.
there is a hole on the back side to hang the Lightbox and a hole on the side for a USB-C adaptor …
If you don't want to use the usb adaptor i have also included a small cap with a 4mm hole just to fit your cable in and another cap without a hole if you want to use a battery pack in it.
Enjoy !
USB-C Adaptor :https://s.click.aliexpress.com/e/_DBngla9
LEDs : https://s.click.aliexpress.com/e/_DnlApXf
Comment & Rating (9)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
magnifique merci
The designer has replied
0
Reply
Beautiful !
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
weird question - is the wall hanger hole with the teeth upside down?
The designer has replied
1
Reply
lol .. yeah just noticed .. Thanks a lot for letting me know i have just correct the files !
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld