Merry Christmas! Elf on the shelf, snowboard, bindings, and goggles. They print pretty easily, though the bottom curved part of the board does need sanding and supports. I used elastic (from a used medical mask) on the bindings and mask.
shouldn’t be. I’ll have a look at the file again and make sure I didn’t miss something when I uploaded it. The only thing I can see that May have caused a sizing issue would be Metric and Imperial. You acn change this by right clicking the item in the slicer and converting to Inches. Hope you come right
thanks for the review. it is a really tight fit but with a little persuasion it goes together and stays together. my daughter uses them for her dolls too. give it a little tough love and I’m sure they will go together no problem 👍