Golf Ball Trophy (Hole in one)
Golf Ball Trophy (Hole in one)
Print Profile(1)
Description
This is a golf ball trophy I designed for a special hole-in-one golf ball.
BOM:
- 1x Trophy Base
- 4x Trophy Stems
- 1x 3 inch by 1 inch nameplate with double-sided sticky pad (purchased)
- E6000 adhesive or alternative
Instructions for assembly:
Print 4x of the trophy stems and 1x of the trophy base, and insert the stems into the slots in the base with the correct orientation. No supports are needed. The trophy base was designed to fit a standard 3 inch x 1 inch nameplate. The stems may require a bit of adhesive at the bottom to be secured - I used a small amount of E6000.
Shown here, the trophy stems are printed in Inland PLA “Twinkling Gold”. The trophy base is printed in Amolen PLA & Wood “Ebony Wood”.
Comment & Rating (0)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
