No Print Profile yet. Add one to earn points.
Christmas Angel picture from HueForge. If you change the order to Black, Gold, or Gray (depending on what you want for a touch), White, and finally a glowing luminescent filament.
Gray and Gold version Description:
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
Filament Black Transmission Distance: 0.3
Filament Grey Transmission Distance: 20
Filament Gold Transmission Distance: 12
Filament White Transmission Distance: 6
!!!! It appears you have mixed filament types. Be certain this is what you want. !!!!!
Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Grey
At layer #12 (1.04mm) swap to Gold
At layer #18 (1.52mm) swap to White for the rest.
Glowing version Description:
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
Filament Black Transmission Distance: 0.3
Filament Grey or Gold Transmission Distance: 20
Filament White Transmission Distance: 12
Glowing Filament Transmission Distance: 6
!!!! It appears you have mixed filament types. Be certain this is what you want. !!!!!
Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Grey or Gold (Depends on your preferences)
At layer #12 (1.04mm) swap to White
At layer #18 (1.52mm) swap to Glow for the rest.
A pokud si model nechcete tisknout, můžete si ho rovnou zakoupit zde:
https://3dstisk.cz/produkt/3d-vytisk-andel/