faucet aerator tightening wrench
Copyright Claim
faucet aerator tightening wrench
Boost
7
3
3
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
15 min
1 plate
0.2mm layer, 2 walls, 15% infill
15 min
1 plate
Boost
7
3
3
0
31
14
Released
Description
If you like my design please don't forget to give me a boost!
With this simple wrench you can tighten or loosen a faucet aerator without damaging the nickel plating. You just have to fit the aerator into the hole and turn, in this way it will be tight or, on the contrary, you can loosen it to clean or replace it.
It will take you to print it max 5 minutes and you will be sure that you do not dent the aerator
Use only the designer´s profiles, they have been painstakingly retouched to exact tolerances for a perfect fit.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect fit. thanks for sharing
1
Reply
It prints well but doesn't withstand the forces at play (PLA). Unfortunately, after that, you might have to discard it.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld