Just wanted to upload this GREAT model by @shakeda to Makerworld for easyer printing from APP (via Print profiles)
Here is the description from Thingverse by Shaked:
Give you the ability to charge your phone in an IDF army car
this is an non active convertor from MS3106A12-5P,MS3456W12-5P,CA3106E12-5P,97-3106A-12-5P that connect a flash light to all IDF Army cars
to a USB car charger.
*ניט 4!
PLEASE NOTE THAT IDF CARS WORK ON 24V AND NOT 12V
car USB changer need to support that voltage
I'm part of makers972 group!
https://www.makers972.org/
no support needed
U will need a rivet size 4 (ניט) radios of 3.8mm (needle size should be about 2.4mm) and a 4awg copper wire
Just us a tool to flip the rivet head.
we may need to heat the if it not fit
source file include
V2. Change head hole size to 3.9 from 3.8mm
Hebrew below
V6. Change head hole size to 4mm from 3.9m
some changes for strength
עברית
מתאם משקע זרקור שקיים בכל רכבי צה"ל לשקע מצית
הרכבים הצבאיים מספקים 24v
רוב מטענים תומכים...
המודל מתאים לניט 4 בגודל שמופיע בתמונות.
כמובן אפשר להתאים לכל ניט.
שימוש בכבל חשמל 4גייג
בהצלחה
להדפיס הצלעות כלפי מעלה
לא צריך תמיכה , יש רדיוס
גובה שכבה :0.3-0.2
אחוז מילוי : 15%
כמות קירות ורטיקלים : 3
חומר :pla לא משנה הצבע
https://www.youtube.com/shorts/4D8zktWiqEU