Ethernet Dust Cover Network RJ45 Plug
Copyright Claim
Ethernet Dust Cover Network RJ45 Plug
Boost
41
87
28
Print Profile(4)
Pack of 20 Dust Cover Print
Designer
1.3 h
1 plate
Pack of 6 Dust Cover Print
Designer
30 min
1 plate
Single Dust Cover Print
Designer
15 min
1 plate
Pack of 10 Dust Cover Print
Designer
45 min
1 plate
Boost
41
87
28
3
145
121
Released
Description
Ethernet Dust Cover
Dust Cover for your networking hardware module; this is a high quality print optimized for 3D printing without the need of brim and overhang support.
Instructions
No model cleaning required after print and smooth edge experiences.
Profiles
The print profiles are set in single, pack of 6, pack of 10 and pack of 20.
Comment & Rating (28)
All
Boosted
Print Profile
Pack of 6 Dust Cover Print
Just what I was looking for. Have a switch in the garage and these give me a little piece of mind since the environment isn’t ideal. Thanks for the model!
1
Reply
Print Profile
Pack of 20 Dust Cover Print
Just what my network needed. Quick easy print.
1
Reply
Print Profile
Single Dust Cover Print
pla-cf with 0.12 layer, perfect!
0
Reply
Print Profile
Single Dust Cover Print
Was fairly loose in my switch, if it was positioned face down they would fall out. I would likely scale just a fraction if I reprinted. Printed just fine, fitted in the slot otherwise.
The designer has replied
0
Reply
Hi, some filaments may shrink when cooled down. So I suggest testing with increasing the X-Y contour compensation in the slicer.
0
Reply
Print Profile
Pack of 6 Dust Cover Print
Prints great and fits in the ethernet ports perfectly
0
Reply
Print Profile
Single Dust Cover Print
Printed in Bambu PLA Matte and the result was a little loose, otherwise print well. Just scanned the comments and saw that I should try adjusting the X-Y contour. Will give that a shot and see if I can get a proper snug fit so the cover doesn’t accidently fall out.
EDIT: Chnaged my rating to 5 stars as changing X-Y contour to 0.1 resulted in a perfectly snug dust cover. I tried 0.2 initially and it was just too large, but 0.1 was perfect! Thank you! 👍🏻
(Edited)0
Reply
Print Profile
Pack of 6 Dust Cover Print
Sehr Praktisch um ungewollte staub Mäuschen fernzuhalten :D
0
Reply
Print Profile
Single Dust Cover Print
Fits well, thanks
0
Reply
Print Profile
Pack of 20 Dust Cover Print
Really nice
0
Reply
Print Profile
Pack of 6 Dust Cover Print
Very nice and simple print
(Edited)0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld