Z-Axis Cover
Remixed by
Copyright Claim
Z-Axis Cover
Remixed by
Boost
16
38
21
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
14 min
1 plate
Boost
16
38
21
0
151
94
Released
Description
Remix of the Z-Axis Cover from DodoIsAlive on Printables.
BambuLab Logo on it, if you want it.
No thin wall detection needed.
Comment & Rating (21)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
works well, printed no logo
0
Reply
👍
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
seems to work great
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Dont fit
The designer has replied
0
Reply
Then try to calibrate your filament pls, it's tight but it fits
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
looks nice, but does not fit on my printer
The designer has replied
0
Reply
Do you print with a calibrated profile? or with a standard profile?
Flow has to be right for it to fit
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Leider passte das keines der beiden Cover obwohl ich sowohl eine Kalibrierung als auch eine Maßhaltigkeitsprobe gemacht habe
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Maße beim p1s passen nicht. min 1mm zu groß bei mir da drückt sich nix
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great profile and model, thank you very much!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed in PLA, and just didn't fit. I do like the design otherwise so I was disappointed I couldn't use them.
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld