AMS side mount spool holder
Remixed by
Copyright Claim
AMS side mount spool holder
Remixed by
Boost
42
68
5
Print Profile(3)
Single color without logo 0.2mm layer, 4 walls, 25% infill
Designer
5.4 h
3 plates
0.2mm layer, 4 walls, 25% infill
Designer
5.9 h
3 plates
Single color with logo 0.2mm layer, 4 walls, 25% infill
Designer
5.6 h
3 plates
Boost
42
68
5
0
120
50
Released
Description
Parts :
5pcs M4 X 16mm
2pcs 608 bearing
2pcs 3 x 8 mm wood screws
1pcs PC4 M5 PTFE connector
5pcs M4 hex nut
AMS:
There seems to be different versions of the AMS. So before you print the clamps, check the rib size of your AMS.
If you have 4 Ribs wich are 65mm - 86mm - 65mm appart, you can print the clamps like they are in the print profile.
If you have 6 ribs wich are about 45 - 43mm appart you have to just print the "Clamp_small_18mm" at least 3 times
Make the ptfe connector hole and the spindle holder hole connected to the mainboard to the desired size with a drill, the holes are marked on the mainboard !
Comment & Rating (5)
All
Print Profile
Single color without logo 0.2mm layer, 4 walls, 25% infill
printed in Petg
0
Reply
Print Profile
Single color without logo 0.2mm layer, 4 walls, 25% infill
nice addon to my ams with my tight space to access the rear spool holder .
1
Reply
Print Profile
Single color without logo 0.2mm layer, 4 walls, 25% infill
had an issue where the eye loop post for the filament broke very easily, but it might just have been because I used PLA.
The designer has replied
0
Reply
PETG or ABS-ASA , PLA it's not good :)
0
Reply
Print Profile
Single color without logo 0.2mm layer, 4 walls, 25% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
Related Models
© 2024 MakerWorld