Florida Gator LED light box by Balorfan85

Balorfan85

Art>Signs & Logos

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

5.9 h

2 plates

5.0(1)

Boost

Released

Description

Florida Gators LED light box! Has a 12mm hole on the side for your cord to go through. I use LED light strips around the interior of the light box, connecting to an 8-10mm solderless clamp, which then goes to a switch adapter and finally inserting to the plug cord.

Comment & Rating (6)

@MooteBuilds

Print Profile

0.2mm layer, 2 walls, 15% infill

a bit thin. make sure to let cool before removing. an extra layer for color would help strength, as I got a tiny separation

The designer has replied

@Balorfan85

I've been working on adding more layers of color recently. This box was one of the first designs I made using the Shurdle tutorial, but since then, it's been recommended to thicken the color just a bit. As far as separation, I've found to let them all cool before taking them off the print bed. Your light turned out so good! Whatever lights you used work very well.

(Edited)

@MooteBuilds

Replying to @Balorfan85 :

my thought is to cut the bottom off, scale the Z axis up maybe to 200%, and then reassemble the edge back to the scaled up front section. the lights I used are a cheap USB strip from ali express. less than a dollar with free shipping.

(Edited)