Ghost by Alec_Bings

Alec_Bings

Art>Sculptures

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 20% infill

Designer

1.5 h

1 plate

4.8(21)

Boost

115

142

Released

Description

Modified version of my first ghost.

This one has a base for holding the tealight in place. It also has a small loop on the back to allow it to be strung up with fishing line or something similar.

No supports needed.

Comment & Rating (39)

@MofWI

The print profile is no longer public

Nice this printed fast and strong. look like a tea light will fit great! I like the hook loop on the back! A little rough bridging on the left arm but not too noticeable.

The designer has replied

@AneoPsy

Thanks for reviewing, I appreciate the feedback.

(Edited)

@Alec_Bings

Thanks for downloading it. I have a friend who has a couple hanging by fishing line from the loop. Looks good in the dark.

(Edited)

@simonfr77

Print Profile

0.2mm layer, 2 walls, 20% infill

Fantastic item and tea light (LED) fits nice and snuggly. Would probably recommend printing in white as the walls are relatively thick and the green didn’t let any light through. or a brighter LED :-)

The designer has replied

@Alec_Bings

I've had some friends want some in orange and some in purple. The orange worked better than purple, but the white definitely lights up better.

(Edited)

@bunchenator

Print Profile

0.2mm layer, 2 walls, 20% infill

printed perfect first try matte ivory white bambu

The designer has replied

@Alec_Bings

Glad it printed nicely. Thanks for downloading it.

@AGUIRRETECH

Print Profile

0.2mm layer, 2 walls, 20% infill

Great print, added a Dollar Store LED tea light, and good to go.

@craigaphill

Print Profile

0.2mm layer, 2 walls, 20% infill

I have printed 4 copies of this model with Bambu Matte White filament. They look great and the light from the tea light shines through the whole body. With Inland PLA+ the light shone mostly through the eye openings and not as much through the solid body. The only defect was some irregular swirling under the left arm as I did not print them with any supports.

@user_2048559016

The print profile is no longer public

The designer has replied

@AneoPsy

Thanks for reviewing, I appreciate the feedback. What was the problem during the print ?

@user_2048559016

Replying to @AneoPsy :

Unfortunately I had moving layer when printing. Unfortunately I can't take a photo because I gave it away. But they were minimal so it was exchanged as a gift. I try it the next Days once again and will show the final result here. greetings

@AneoPsy

Thank you for your response, interesting about the moving layer, if you have the opportunity to send a picture, I’m interested so I can re-tune the profile.

(Edited)