A simple charging stand suited for an existing standard and two watch MagSafe connector to show off iOS 17's new ‘StandBy’ feature.
--Features--
- Horizontal display angle for phone charger so it can be seen easily on a bedside table while laying down
- The base comes in two parts with 10x 12mm holes to insert small fishing sinkers to weigh down the base (optional)
- All parts slot together well without the need for glue, feel free to add some if desired
- Pinhole on the back of the charging slots to assist in pushing out the charger if required
- All cables are routed through the stem of the stand so they cannot be seen
- Cable track on the underside to allow the base to be placed flat and cables exit from the rear of the stand
- Can mix and match which charger blocks are used in each position
--Assembly--
- Fill the circle holes in the base with weight (optional)
- Align the upper and lower bases and push together
- Push the stem piece into the base
- Slot each magsafe charger into its charging block
- Feed the cable through the hole and down the stem
- Slot the charging block into the stem