Weighted Gear Bearing Fidget Spinner
Remixed by
Copyright Claim
Weighted Gear Bearing Fidget Spinner
Remixed by
Boost
5
15
6
Print Profile(1)
0.16mm layer, 3 walls, 20% infill, with supports
Designer
2.1 h
1 plate
Boost
5
15
6
0
18
21
Released
Description
I remixed this spinner to add a ring around the outside. This adds more weight so it will be able to spin longer.
After printing, a 1/4" hex key can be inserted into the middle to help break the gears loose if necessary. Top and bottom caps fit through the center to provide a place to grasp it while spinning.
Comment & Rating (6)
All
Print Profile
0.16mm layer, 3 walls, 20% infill, with supports
due the print not being flat it did not print correctly. it did spin nicely but the bolt did not go in all the way.
The designer has replied
0
Reply
Looks like a filament problem. Silk can be tricky and if you used the profile I provided, it was not set up for silk.
(Edited)2
Reply
The print profile is no longer public
poor overhangs. May have been better with supports.
The designer has replied
0
Reply
I uploaded a new profile.
0
Reply
Print Profile
0.16mm layer, 3 walls, 20% infill, with supports
worked off the plate
0
Reply
Print Profile
0.16mm layer, 3 walls, 20% infill, with supports
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld