Patin antidérapant coque Amiga 500 / Amiga 500 case anti-slip foot

EN :

Hello everyone,

this is my first attempt at printing in TPU (TPU-85A NinjaFlex), not without difficulty I must confess.

These are replacement pads (feet) for the Amiga 500 shell.

the skid dimensions are as follows:

overall height: 5mm


Amiga shell side part :


    diameter 13mm


    height 1.5mm


foot


    height 3.5mm


    diameter 11 millimeters then 10.30mm on the part that touches the "ground

The print was made on an Artillery SideWinder X2, it's my first try with TPU, the quality of my print is not yet optimized.

EN :

Hello all,

This is my first attempt at printing in TPU (TPU-85A NinjaFlex), not without difficulty I must admit.

These are replacement pads (feet) for the Amiga 500 case.

the dimensions of the foot are as follows:

total height: 5mm


Amiga case side part :


    diameter 13mm


    height 1.5mm


foot


    height 3.5mm


    diameter 11 millimeters then 10.30mm on the part that hits the "ground"

The print was made on an Artillery SideWinder X2, it's my first attempt in TPU printing, so printing quality isn't quite optimized

FR/FR

Raft: No

Supports: No

Resolution: 0.2mm

Infill: 100%

Filament Brand: NinjaFlex

Filament Color: Snow

Filament Material: TPU-85A

Printing at 20mm/s

no shrinkage

40° printing plate

220° printing temperature

EN/UK

Rafts: No

Supports: No

Resolution: 0.2mm

Infill: 100%

Filament brand: NinjaFlex

Filament color: Snow

Filament material: TPU-85A

Print speed at 20mm/s

No retractation

Bed at 40° Celcius

Print temperature at 220° Celcius