Hi...
i was looking for a Minecraft Lamp for my Son but could not find what i was looking for...
So this came to life :)
All files are in the 3mf File... I designed it to fit on a Bambu Lab X1C...
i used the following settings:
No Flow Calibration!
For the sides/top: 5 Top Layer, 15% infill, 4 Walls. Color Change from grey to black at layer 28. 5 or more Top Layer so the infill is not visible ;)
For the Bottom/middle parts: anything, 4 Top Layer, 15% infill, 4 walls for me. Not so important.
I bought 3 rolls of Sunlu PLS+ grey, 1 Sunlus PLA+ black and 1 eSun ABS white (3 Layer). The white plates are glued from inside.
The Lamp sockets: https://www.amazon.de/dp/B0B8WTYPY9
Power socket: https://www.amazon.de/dp/B07Z3FVFTF
Power switch: https://www.amazon.de/dp/B08CY5437N
You need some M3 inserts (2 power socket, 2 for each Lamp socket) and screws (2x M3x10 each lamp, 2x M3x6 countersunk for power)
I use Zigbe RGB Lamps E14 bulbs to control with Alexa...
I needed to file down the teeth a little so it can fit. I found out that no glue is needed when you leave some edges. Use a little force to press the parts together and they stay without glue... If you can compensate Elephant foot then this is no problem... But it was done in 5 Minutes after each plate, no big deal...
I hope your Kids like it...
Three cubes are 72cm tall so its a nice decoration for Minecraft lovers :D
If you have any problems with the files please contact me, i help where i can...