My sister asked me to design a solution to allow her to hang fruits/vegetables off the ground for her chickens to feed on.

Print Settings

I used 4 walls and 20% infill.

I would use ASA If you don't want to keep reprinting from UV damage.

Assembly

You will need:

5x 3mm diameter rods at your desired length. I used 3mm x 200 I had bought previously from amazon.

Depending on your printers calibration the rods should be a tight fit but superglue or epoxy won't hurt.

The “end knobs” push fit on the ends so the chickens don't poke their eyes out lol.

Printing Note

Please flip the “Chicken Hook” stl when printing so the teardrop shape has the pointy end up as pictured below.

Thank you!