New version available here!
A revised version of a simple remix of a the Desiccant Spool Carrier for Bambu Lab's spools. It can be kept in the spool while printing and in storage. The initial remix replaced the holes in the lid with a cut-out for a hygrometer, mainly useful during storage, and has a very tight fit, to keep the hygrometer from falling out.
Update: Added a new version with two lid options that include a channel to allow air to pass into a hygrometer chamber. This version keeps the desiccant from getting into the hygrometer, and has a looser fit to more easily remove the hygrometer for replacing the batteries.
Build plates:
The new containers are a bit shorter than the originals, to account for the increased height of the new lids. The distance between the inside faces for both v1 & v2 is 63mm. You can mix and match the old lids with the new containers for a narrower spool (57mm), or the new lids with the old containers for a wider spool (69mm).
Note: The perforation of the lids and containers is not shown in the build plates or previews. The effect is achieved during slicing by removing the top and bottom layers, and using a dense, honeycomb infill (to keep the desiccant from passing through)
Related model: Threaded funnel can be used to fill and empty both versions of the containers.