This inlay is to compliment my other inlays for Werckmann / Action Store organizer boxes.

I just figured that I never need my CNC Kitchen TS-100 soldering tips without my threaded inserts and vise versa, so I can as well just store them alongside each other.

The inlay for the iron is large enough to store it with any of the tips attached, so if you mainly do M3 you don't always have to (un)screw the tip. The inlays are as raised as they are so they get held by the lid and don't dislocate even when the box is flipped 180°.

There's a little compartment, e.g. for storing an allen key to change the iron on the TS100 directly.

To get the iron out, you just push it down in the rear so it raises in the front, as seen in the photos. There's just very little space and this seemed as an elegant solution to get it out regardless of the size of your fingers.

printing advice.

I added printing profiles for multi- as well single colour; I wanted this model and the text to work for anyone, which is why the text is raised and not embedded flush. I lowered the layer height to 0.2mm because there's a lot of fillets and I like the look better, but you can easily lower it to 0.28 if you don't care.