These are designed to mount an Eve Motion sensor.

Corner Mount with Screws and 3M Strip

This mount for the Eve Motion sensor fits 90-degree inside corners and tilts the sensor 10 degrees downward. It includes both options for #10 flat head screws and 3M adhesive strips for versatile mounting options.

Corner Mount with 3M Strip

Designed for the same 90-degree inside corner fit and 10-degree downward tilt, this version of the Eve Motion corner mount comes exclusively with 3M adhesive strips, offering a screw-free installation.

Each has an angled and non-angled version.

Tips

• Walls are often not 90 degrees - check with something that's known to be square - screws are often easier to use in this case.
• Pre-drill for the screw option into the wall - you may find an inside metal corner bead that screws won't want to go through.
• Keep layers perpendicular to the mount post, not aligned with it - don't lay the part on it's “back”

To Install

1. Apply 3M Adhesive to two sides AND/OR
2. Pre-drill holes into wall using Corner Mount (with screw holes) as guide - use smaller drill bit than the screw.
3. Push into corner and if applicable, screw into wall to snug. Don't overtighten
4. Insert Corner mount peg into Eve Motion backside into the wider part opening of slot Might be tight (good).
5. Slide down with minimal force till the peg is at the top of the slot and the bottom corners of the sensor should nearly touch the wall.

Our Favorite Things for 3D Printing

Includes Affiliate Links

• #10 Screws - 1.25" long
• 3M Command Strips
• Nano Adhesive - Stop using glue sticks - this is 1000% better 😉
• 6mm Magnets
• Plastic Debur Knife - clean up plastic edges (brims)
• Small Clamps
• Assembly Glue

PDX CNC Products