This dog was an absolute pain in my ass to assemble, even though I printed the 50% bigger size. It might of just been me but some assembly instructions would be nice as the photos are kinda hard to see where all the pieces go.
The neck skeleton part needed a brim to print, it would not stick to the plate otherwise.
The rest of the skeleton did not need a brim.
The very back part of the armor is loose and a dab of glue is probably a good idea, it stays on but its very unstable.
All that said, I do like this dog.
joli modèle, très sympa, très réaliste au niveau des postures possibles 🙂
... mais trop cassant en pla
j'ai imprimé le grand modèle, toutes les jambes à clipser ont cassé au niveau du clips. j'ai collé 😉.
il faut coller les pattes, une a cassé au clipsage.
je pense réessayer en petg 🙂