TPU "Rubber" band
Copyright Claim
TPU "Rubber" band
Boost
15
10
6
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
12 min
1 plate
Boost
15
10
6
0
49
39
Released
Description
I made this mainly to fit into the katana found here- https://makerworld.com/en/models/39368#profileId-38480, but it can be adapted to other uses, just change the scale in the slicer to fit your needs. printed in 95a amolen tpu and can be a bit tough but does infact strech and suit the needs i made it for!
Comment & Rating (6)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
simple, very good to test tpu in a quick way
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
the flexibility is depending from the used material.
(Edited)0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Other Issues:not that stretchable
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld