Swifty - the fast laptop riser

I needed to lift up my laptop a bit, but most of the designs i found take too much time to print, plastic and are too big for my needs.

I designed Swifty of wich you need 1 left part and 1 right part. Simply attach it to the upper part of your keyboard section ( see picture ).

I have tested it on 3 laptops i own, Asus, Lenovo and HP. I am sure there are tons of laptops it fits and tons it does not, but it should fit every laptop with the right proportion of scaling.

Both parts together should take less than an hour with 5 perimeters, top/bottom and 30% Gyroid infill - wich i recommend.

I have printed it in Bambu PLA-CF for the looks.

Would love to upload my print profile, but for some reason i am getting the message that its not sliced in B.Studio. Oh well.

Enjoy!

UPDATE : Swifty V2

Updated the design to make it use even less plastic and more importanly there is no more danger to break you display if you forget you have them on ( most laptops)!

I left the v1 version there also, but i recommend you download the V2 left and right.