überarbeitetes Model und Druckprofil. Einige stabilitäts Optimierungen am Model und am Profil an sich. Keine Sorge, alle Anschlüsse passen wie gehabt. (25.02.2024)
Winkelanschluss 90° hinzugefügt ( 24.02.2024 )
neue Anschlüsse hinzugefügt ( 23.02.2024 )
Version mit einer maximal Höhe von 249mm für Bambulab Drucker ist verfügbar! ( 29.11.2023 )
Vakuum Ventil 100% aus dem 3D Drucker ist nun verfügbar (06.01.24)
https://makerworld.com/es/models/126731#profileId-137035
Ein Zyklonabscheider für die Werkstatt.
Sondert den groben Dreck in ein extra Fass/Eimer ab.
Dieser ist speziell für die Anschlüsse von Bosch und Fein Akkustaubsaugern gedacht, da die dazugehörigen Adapter erst nachträglich eingeklebt werden, kann auch für jeden anderen Schlauch ein Adapter angefertigt werden.
Der Anschluss mit der Schräge ( Innenseite ) ist für den Anschluss Unten ( horizontal ). Hier wird der Dreck in Richtung Zyklon eingesaugt.
Der andere Anschluss kommt oben drauf und führt zum Staubsauger.
Keine zusätzliche Verschraubung, durch das angebrachte Gewinde, notwendig. Lediglich abgedichtet mit Silikon oder ähnliches sollte es sein.
Ein Unterdruckventil, um das implodieren des Behälters zu verhindern, wäre sinnvoll.
Material bei mir war PLA+
ENGLISH
revised model and print profile.
Some stability optimizations on the model and the profile itself.
Don't worry, all connections fit as usual. (02/25/2024)
added angle connection 90° (02/24/2024)
added new connections (02/23/2024)
Version with a maximum height of 249mm for Bambulab printers is available! (11/29/2023)
Vacuum valve 100% from the 3D printer is now available (06.01.24)
https://makerworld.com/es/models/126731#profileId-137035
A cyclone separator for the workshop.
Separate the coarse dirt into an extra barrel/bucket.
This is specifically designed for the connections of Bosch and Fein cordless vacuum cleaners.
Since the associated adapters are only glued in later, an adapter can also be made for any other hose.
The connection with the slant (inside) is for the bottom connection (horizontal). Here the dirt is sucked in towards the cyclone.
The other connection goes on top and leads to the vacuum cleaner.
No additional screw connection necessary thanks to the attached thread. It should only be sealed with silicone or something similar
A vacuum valve to prevent the container from imploding would be useful.
The material for me was PLA+
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.