“Roads? Where we're going, we don't need Roads!”
This is my first Hybrid Hueforge, so let me know what do you think about this project.
I Used Elegoo PLA and PLA+ from my old printer but you can use different.
For the Hueforge, (0mm - 1.92mm) Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
For the Delorean (1.92mm - 40mm) Print at 10% infill, with a layer height of 0.2 mm, (but less is better) with 3 wall loops, 3 top and bottom surfaces.
- For change parameters of Delorean, select the object and using “layer height modifier”
- Change Parameters Here
NO Support required
Swap Instructions:
Start with Black
At layer #11 (0.96mm) swap to Ice Blue
At layer #19 (1.6mm) swap to Jade White.
At layer #23 (1.92mm) swap to Silver for the rest.
------------------------------------------------------------------------------------------------------------------
"Strade? Dove andiamo noi, non ci servono Strade!"
Questo è il mio primo Hueforge Ibrido, quindi fammi sapere cosa ne pensi di questo progetto.
Ho usato Elegoo PLA e PLA+ dalla mia vecchia stampante ma puoi usare i colori che vuoi.
Per la parte Hueforge, (0mm - 1.92mm) Stampato al 100% di riempimento con altezza layer di 0.08mm ed altezza primo layer di 0.16mm
Per la Delorean (1.92mm - 40mm) Stampato al 10% di riempimento, con altezza layer di 0.2 mm, (ma meno è meglio) con 3 pareti di loop, 3 layer guscio superiori e 3 layer guscio inferiori.
- Per modificare i parametri della Delorean, selezionare l'oggetto e utilizzare "modifica intervallo di altezza"
- Cambia i parametri nella sezione raffigurata nell'immagine sopra.
NESSUN Supporto richiesto.
Istruzioni per cambio colore:
Inizia con il Nero.
Al livello n. 11 (0,96 mm) passa a Ice Blue (Azzurro cielo)
All livello n. 19 (1,6 mm) passa a Bianco.
Al livello n. 23 (1,92 mm) passa a grigio chiaro per il resto.