If I put the tit dumpling in my Emsa bird feeder, crows and magpies carry the tit dumpling away. So I created a theft protection which fits the hook in the bird house. Of course you can use it without the Emsa bird feeder if you find another hook to hang it on.

It prints without support and brim. A challange could be collapsing vertical walls because of to much heat in the part during printing. Set up higher minimal layer time and/or stronger part fan should help.

When I slice it a problem at the moment are the first bridges. At first bridging layer it starts with the bridges and than prints the lines on the pole, so the bridges starts in the air. It prints the rest of the model fine so you only have to remove the bridges hanging around. You can see the finished model without post processing in the pictures.