D20 Dice Box magnetic by Preischl 3D

Preischl 3D

Toys & Games>Board Games

Print Profile(4)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.2mm layer, 2 walls, 15% infill

2.6 h

1 plate

4.8(35)

0.2mm layer, 2 walls, 15% infill NO SUPPORT

2 h

1 plate

4.9(14)

[A1-mini] 0.2mm layer, 2 walls, 15% infill

3.9 h

1 plate

5.0(2)

0.2mm layer, 2 walls, 15% infill

2.7 h

1 plate

Boost

183

326

398

434

Released

Description

NEW: D20 dice box with imprinted magnets -> Exclusive model in my club

Do you like my designs? I would be happy if you would support me by joining my Printables club! :) (already from 3$) It also gives you access to exclusive models ;) https://www.printables.com/@Preischl3D
Or do you want a sales licence? Then you can book the commercial tier!

All models I publish are tested by me and my community before I publish them.

Here you get a D20 Dice Box that has been designed so that you can insert round 5x5mm magnets.
This gives a secure hold of the lid for transport and looks super sexy.

If you use flatter magnets, you can simply print a suitable spacer and glue it in place.

Tip: The magnets are best glued in place with a good superglue or most definitely with 2-component epoxy glue.

Comment & Rating (55)

@user_444684539

Print Profile

0.2mm layer, 2 walls, 15% infill

wow! turned out so well!

@user_83989370

Print Profile

[A1-mini] 0.2mm layer, 2 walls, 15% infill

It’s very nice and prints easily. The holes for the magnets are too deep, so we had to fill them before putting the magnet.

@RotePatrona

Print Profile

0.2mm layer, 2 walls, 15% infill

nice and easy print. I didn't have 5x5 magnets, but I simply printed small discs as a base so that I could use my 5x3 magnets.

@AverageDadPrint

Print Profile

0.2mm layer, 2 walls, 15% infill

Turned out pretty good. Used copper PLA color.

@Speedracer30

Print Profile

0.2mm layer, 2 walls, 15% infill

looks great in silk

@Roc3D

Print Profile

0.2mm layer, 2 walls, 15% infill

very good quality finish so good

@chriskillen

Print Profile

0.2mm layer, 2 walls, 15% infill

Great model! I turned supports off and it came out perfect.

@ihdavids

Print Profile

0.2mm layer, 2 walls, 15% infill

@user_2467728565

I’m very new to the modelling side of this hobby. is there a way to print numbers in another colour to insert into the voids?

The designer has replied

@Preischl3D

I haven't included this because many numbers are printed at different angles and not everyone has a handle on their printer so that the cut-outs fit cleanly and look good with inserts. If you want to do it, you could, for example, insert cubes on each side in 3D Builder and cut them out.