No Print Profile yet. Add one to earn points.
Whoop fitness uses an unusual battery solution to charge the Whoop fitness band. Rather than directly charge the watch itself, you charge an external battery and put in on the watch to recharge the watch battery.
This works well,but it means you have loose battery packs lying on your desk and when you charge them they tend to get flipped over by the micro-usb cable and you cannot see the charging status light.
This project is my attempt at a solution. A small, desktop charging dock for the Whoop battery.
You will need to buy the following parts to complete this project:
Two M3x8mm hex screws are required to attach the base plate.
StarTech.com 3 ft / 91cm Micro USB Cable - A to Left Angle Micro B - USB Type A - 90 Degree Micro-USB Type B (M) - Black (UUSBHAUB3LA)
Once you print out the back plate, the base and the base plate you can assemble everything.
DO NOT GLUE THE BACK PLATE IN PLACE WITHOUT READING THIS FIRST
If you are planning on buying a whoop, use this link for a free month of service!
Printer Brand:
Creality
Printer:
Ender 5
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20
Filament:Cheap PLA black
Category: Sport & Outdoors