Update: I have added a profile for people with NO AMS unit. For the NO AMS profile you will need to manually unload/load your filaments as described in the “Swap Instructions” in the order below at each pause. I have also added a layer height modified to all 3MF files to speed up the of the black filament by printing it at 0.16 layer height.

This ornament is perfect for hanging on a tree or as anywhere else, and also for a gift. The photo attached is the printed ornament.

Like all Hueforge prints this model produces very little waste (7 poops total).

Some of my other prints have more notes and tips for first time Hueforge printers.

IMPORTANT: READ BEFORE PRINTING

I have uploaded two 3MF Files along with the STL. The First for 1 AMS and the second for people with 2 AMS units.

To print this with 1 AMS unit you need to manually switch out your black (ams slot 1), red (ams slot 2) and yellow (ams slot 3) to azure blue (ams slot 1), ice blue (ams slot 2) and white (ams slot 3) when the black, red and yellow have completed and fully retracted. You can swap each color as its corresponding ams slot above finishes or wait for the darker blue to start and switch all three at once. (Note when swapping mid print the AMS unit does not auto feed the spool like it does before you start printing, so make sure you push at least three to four inches in and that the light indicator goes on. When it comes time to print the 5th color (azure blue) it will feed as normal.) If you substitute colors results will vary.

If you have two AMS units just use the 2 AMS print profile, load the filaments as below and print.

If you do not have an AMS, fear not, you can still print this by changing your filaments manually.

Avoid other print profiles that try to save time by using a thicker layer height. This layer height is necessary to blend the colors.

This model is for personal use only.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA PolyLite Red Transmission Distance: 1.1
PLA PolyLite Yellow Transmission Distance: 10
PLA PolyLite Blue Transmission Distance: 1.1
PLA PolyLite Azure Blue Transmission Distance: 3
PLA BambuLab Matte Ice Blue Transmission Distance: 3.5
PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #15 (1.28mm) swap to Red
At layer #18 (1.52mm) swap to Yellow
At layer #20 (1.68mm) swap to Blue
At layer #22 (1.84mm) swap to Azure Blue
At layer #30 (2.48mm) swap to Ice Blue
At layer #35 (2.88mm) swap to Jade White for the rest.

Happy printing.