3d scanning rotary plate (photography)
Copyright Claim
3d scanning rotary plate (photography)
Boost
13
22
9
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
6.1 h
2 plates
Boost
13
22
9
0
38
31
Released
Description
It's quite useful if you want to make close up video clips to look better.
Overall this design works pretty well and I have already made a lot of nice shots with it.
Parts list:
-Arduino
-28byj-48 stepper motor with driver
-3x 608 bearing (8x22x7mm)
-2 screws to mount the motor
-on/off switch (optional)
Contact me if you need arduino setup instruction or code!
Comment & Rating (9)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Fine, but I forgot about openning door with pla printing 🥲🤣
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
guess you will need 4 bearings, is the center same size?
The designer has replied
0
Reply
Yes, all the same. You can only use only one, central bearing, works without issues.
0
Reply
Replying to @Milicjovan
i was told the stepper moter can not keep spinning like a normal moter. it needs to spin back after a bit. is that right?
0
Reply
Replying to @kristian205
You can do this with arduino, just upload custom code
0
Reply
The author does not respond to messages regarding the device's software. Even though the description clearly says to ask for a code, you won't receive one. For people who don't know how to write code, the model is useless. I'm sorry.
0
Reply
how do I get instructions and code?
0
Reply
Hi, is it possible to have instructions and code for Arduino? Thank you very much.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld