Large propeller for Pull Copter (No Supports)
Remixed by
Copyright Claim
Large propeller for Pull Copter (No Supports)
Remixed by
Boost
39
69
19
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
31 min
1 plate
PLA 0.20mm
33 min
1 plate
PETG 0.20mm
36 min
1 plate
Boost
39
69
19
0
132
92
Released
Description
This is an even larger propeller for the Pull Copter (https://www.printables.com/model/227852-strong-flying-propeller-pull-copter-no-supports).
I made it 225mm, which fits nicely on the X1C print bed without needing to remove the calibration lines.
Comment & Rating (19)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
30 minutes and done
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Some of the layers did not adhere.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Glad you liked it!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
Thanks for sharing the print! Looks like it came out well :)
0
Reply
Print Profile
PLA 0.20mm
grea print, fits the copter good
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
A good extension to the flying copter.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
0
Reply
hey! Sorry it didn’t work out for you! any suggestions for improvement?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld