No-Support Siren Whistle
Copyright Claim
No-Support Siren Whistle
Boost
78
127
85
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
46 min
1 plate
0.2mm layer, 2 walls, 15% infill
51 min
1 plate
Boost
78
127
85
0
295
498
Released
Description
Building on the design ideas of other whistles, I'm seeing 105dB on my phone's meter.
Prints well at 0.1-0.2mm, no supports required.
Make sure the rotor is free from elephant-footing and can spin freely.
A small dot of oil on the center shaft will help it run smoothly.
Quite loud and responsive, actually.
Comment & Rating (85)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Da werden kindheitserinnerungen wach
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed fine, but did not whistle well for me.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Quick print and works great
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great whistle printed perfect
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
loud af
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fonctionne mais petit defaut sur l exterieur.
0
Reply
easily overwhelmed by air, but cool
0
Reply
Worked well with PLA.
Oiling the small hole was necessary, as stated in the description by the maker.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Smart thing, but all parts won't keep together, even when you press them
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld