Wall Socket and cable organizers J1772 by luckyluc.64

luckyluc.64

Tools>Organizers

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 15% infill

Designer

2.3 h

1 plate

4.8(11)

0.2mm layer, 4 walls, 15% infill

4.9 h

1 plate

5.0(2)

Boost

Released

Description

No, I don't just do things for my Bambu Lab machine ;-)

Here is a J1772 wall socket / cable organizer. One did come with the Emporia charger, but I wouldn't say I liked it. For a bit of time and under $1.50, I have something cool that goes with my cooler car.

Ya, it's a J1772. It's not for the snob that has Tesla, LOL.

At first, I printed it with Generic Blue ABS, and it didn't go too well on the wall with all the B&W things.

I hope you like it.

Comment & Rating (26)

@strasb

Grate model and it works well. Made a new profile for it in ABS with thicker walls and a different finish. Takes 2 times as long to print but I thinks its worth it =)

(Edited)

The designer has replied

@luckyluc.64

Oh, Nicely done. Did you use a concentric surface? This model is slow; it's there for 3 mounts or more, and I only have 26 prints and 29 downloads. Maybe I should put it on FB to see if more people need it.

@strasb

Yes, used consentrc as the surface finish was nicer then normal. had some issues with the surface quality on normal mode.

@dannavarrojr

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Came out spectacular even without supports. very strong print & great design.

(Edited)

The designer has replied

@luckyluc.64

Thank you but you are the hero here. You did an excellent job printing-it, it does look sweet. Yes, All my stuff I design, I avoid waste and support like it would give me the Covid LOL. Enjoy and thanks for having an EV.

(Edited)

@pieropenguin

Print Profile

0.2mm layer, 2 walls, 15% infill

printed in eSun PETG and looks great. will be mounted indoors so hopefully will last better than PLA. if now, will reprint in ABS or ASA.

The designer has replied

@luckyluc.64

Thanks for downloading it and rating it. I almost never use PLA. I don't see an issue if it's inside other than the tab that hold the J1772 connector. If it was outside ASA or even PC would be the best. Enjoy and keep having fun printing.

@steven.francisc

Print Profile

0.2mm layer, 2 walls, 15% infill

works great.

The designer has replied

@luckyluc.64

Ah! yellow Steven Excellent printing job. It looks great. I like it yellow. Thanks for the download and the rating.

@superintendent

Print Profile

0.2mm layer, 4 walls, 15% infill

great. printed with PLA. the top is big enough to place several loops of the cord around. tolerance for the tip end is a little large but understandibly made so to make it easy to clip it in and out without any problems.

@VRsculpts

Print Profile

0.2mm layer, 2 walls, 15% infill

looks good fits my adapter haven't mounted to wall yet

The designer has replied

@luckyluc.64

Excellent. I think it does look good, too. Thanks for downloading it and giving feedback. I appreciate it. I invite you to look at my solutions for BBL's little corks.