L'OR Coffee Pod Dispenser
Copyright Claim
L'OR Coffee Pod Dispenser
Boost
2
7
3
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
3.7 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
5.5 h
2 plates
Boost
2
7
3
0
11
9
Released
Description
I could not find any coffee pod dispensers that would work with the L'OR coffee pods. This can be modified by scaling up slightly to work with K-Cups. This is my first design, any advise you might have as to hos to make this better, or what tool to use (I did this in Bambu Studio), would be appreciated. Thank you
Comment & Rating (3)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
For the most part this printed out fine. The only issue I had was with the word decaf. With no support the start of the letters drooped and do not look good. If you bevel the letters to a 45 or something similar then the letters should come out better.
The designer has replied
0
Reply
Thank you, I saw that, I will fix this and reload. Sorry about that.
(Edited)1
Reply
I fixed the DECAF issue, and added more "fuel" windows to the sides
(Edited)
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld