Octahedron Fractal, Base included! Remixed by Sandholm

Remixed by

Sandholm

Household>Decor

GIF

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

#2 OCTAHEDRON

Designer

13.7 h

2 plates

5.0(7)

#1 BASE/STAND

Designer

2 h

1 plate

4.9(7)

Boost

100

Released

Description

This is the octahedron version of TBone_427120's pyramid fractal!

VASE MODE

DO NOT change any parameters!

PRINT AS IS
.
READ THE ORIGINAL POST FOR MORE INFO REGARDING THIS:

https://makerworld.com/sv/models/18654#profileId-23282

>>>PRINT BOTH PROFILES<<<

>>>PRINT BOTH PROFILES<<<

There are 2 print profiles due to Bambustudio does not support multiple different print types on different buildplate within the softwere itself. The base and the two separate pyramids are printed differently.
I have included the correct pyramid version ,(by TBone_427120) on this page and the base to complete the octahedron itself.

Assembly. The octahedron can balanced on itself without issue if the piece will stay stationary in its spot. Add a few dots of glue to secure it. Add even more, if the piece will be handled a lot!

Comment & Rating (26)

@golub17

I am currently in the process of slowly and painfully pulling it off a build plate, it sticked too well. Did you used a different plate or glue stick? My usecase: PLA silk, Textured PEI

The designer has replied

@Sandholm

oh wow..! no i used textured pei too. it just slid/popped off after it cooled down, as it should with that plate. make sure the plate is 100% clean using IPA or dish soap. other than that just double-check so you dont have any "pre made" parameters in Bambu studio. this should not happen at all using the print-profile..!

@Sandholm

0.4 nozzle too

@golub17

Replying to @Sandholm :

Well thats the problem, my plate was definitely clean and it sticked so well that it was unable to pop off, as you can see on the picture, the first layer holds on like hell. I has to scrape it with razor. Also it was cooled down overnight so no hot plate when it happened.

@Noerakh

Print Profile

#1 BASE/STAND

It turned out so great!

The designer has replied

@Sandholm

Very nice choice of color pallette, looks very clean!

(Edited)

@Noerakh

Replying to @Sandholm :

thanks! :)

(Edited)

@Toprharley

Wow, what an awesome print! Converted all of the settings from bambu to my anycubic slicer and this thing printed out like a dream. It looks so cool. Printing the second half today and then the base. Ill post pictures once its fully complete. Can't wait to try this on my A1. Just have to find that perfect filament. Anyone with a 3D printer should be printing this. one was printed in a tri-color matte and the other is the gold/red amolen silk-like pla. the amolen printed on my kobra neo 2, the tru-color was done on the A1.

(Edited)