Attach a little bit of double sided tape like this can help hold the bin place.
While testing my model https://makerworld.com/en/models/47982 AMS Fix Failed To Pull Out Filament Error, my waste bin got so full and i needed to empty it every few hours, figured that i needed a bigger one. Also i realised that there is some upgrade that can be done to the original model so…
I present to you the “POOP IT OUT Pull Design Chute Container Bucket - Large Capacity, Convenient, Smart, Ez To Use”.
Some problems i met using the original bucket
-Small collection area so the bucket fills up quickly.
-The angle of the slope is not fantastic i have many poop stuck on the slope instead of going into the collection bin area.
Here is some changes that i have made
-Pull out to clear filament waste poop design, push back in when done.
-The angle of the slope that the poop falls down from is greatly increased so poop should fall down easily.
-The collection bin size have been almost doubled so it can collect much mre waste.
-The drop zone after the downslope have been optimised so it can slide down mre efficiently and waste can accumulate properly.
-I have always love the slim profile of this poop bucket so i have retained it's slim profile and increase the capacity by extending it upwards instead.
Might not be suitable if you are using a rear spool holder originally from Bambu. This might block that holder at the back of the printer. Thank you.
What Mod / Fixes / Enhancement do i offer?
Please don't download the wrong one. Only those in the photos below is designed by me who painstakingly took a lot of time to measure carefully and design just to get it working. #SupportOriginal Love you guys for all the support so far!
I'm confused. I pulled down all 4 variants and all of them have hard angle corners on the side of the pull-out tray where the logo goes (or doesn't) versus the one in the video that has the rounded corners. How do we get the one in the video?
I was about to add a few 15x3mm magnet holes to the ramp but paused to see if there is a different model you have available with the rounded corners.
Can you make a rounded corner version of the v2 pull out tray? Aesthetically I think it's more pleasing than the hard corners of the current one. If not, then you might want to take down some of the pictures of the rounded pull out tray as it is confusing.
Hi i will pull down the rounded corners photo. Since V2 is a improved qnd working version, there is no point for me to make it rounded. Thank you for the info.
Hi i have just did a cut and print at the area you have string like problems at. Seems perfectly fine. If you want you can print the pull out container again. Thanks again.
great design. I like how it has the removable tray. makes it easy to get rid of filament waste. I also throw all my other filament waste in the pull out tray till I am ready to empty all.
Nice design with the removable dump tray. However this design does not allow a external spool to be used with the factory spool location. The high side wall runs into the spool. Kinda wish I knew this before I started the print. Might want to modify it to reduce the side wall height in the rear.