UPDATE : Version 2 now available with a stronger screw hole and half the width : https://makerworld.com/en/models/198745
After downloading the wonderful oversized magnetic poop bucket from Nivenante I noticed a little issue.
https://www.printables.com/model/395219-bambu-lab-magnetic-purgeflushpoop-bucket-for-x1-an
The machine would poop and it would catch the lip of the bucket and still end up on the floor. I designed this little deflector to ensure the poop was redirected into the bucket every time.
It's deliberately designed slightly short of the height that most poop buckets are made so that removal of the poop bucket doesn't get tangled on the bottom of the deflector.
The screw hole is designed to be very tight and self threading to keep the deflector in place.
You can use the pre-installed M3 8mm bolt from the printer directly above the chute to mount it - or any M3 8mm bolt or screw will probably work as well.
UPDATE 31-Jan-2024 - Updated the print profile to include a brim due to small surface area in contact with the build plate.
PRINT INFO:
Printer : X1 Carbon
Profile : 0.20mm Standard
Material : PLA
Brim : Yes
Support : No
Filament Used : ~22g
Print Time : ~34 min
Sparse Infill : 5%
Infill pattern : Gyroid