Update: V2 is released! Improvements include:

• Improved/intentional controller mounting spots
  • previous spots to hold controllers were a happy accident
• Improved cable holder
  • made it shorter, made the securing angle steeper
• Improved headset mounting position
  • moved headset mounting position closer to the wall and made the mountable space for the headset smaller, because there was a good bit more room that was needed in the slots before.
• Changed where the mounting screw holes were
  • new ones are further out. If you are replacing c0d3c's or my v1 with this, I've included a file with the older mounting hole locations. If you are printing this design for the first time and not retrofitting it, I would recommend using the new mounting hole locations.
• Now prints without supports

————————

This is a remix of c0d3c's original design to store the headset in a position where dust doesn't settle on the lenses. I added a spot to hang the cable on as well as a Playstation logo for kicks. Also found that this hanger functions really well to hang the controllers on as well.

Share your makes and show off your setup if you print this one!

Print settings:

I printed mine in the orientation shown in the above slicer screenshot included above. Minimal supports required, and it seems plenty strong for its purpose. I'm not going to go being rough on the thing, but to hold the weight of the headset and controllers, it is plenty strong.

I would recommend increasing the number of walls. In my case, I printed at 0.16mm layer height with 4 walls and 30% infill.

Update: for V2, you will likely have to rotate this part on your bed to make it fit. In that case, I would recommend changing the infill direction to be 45º if you are using default grid infill.