This is a replacement stronger propeller and nose cone for a Quick Build Mustang P-51D Model Kit (J6016). The original propeller lasted just minutes in the hands of a four year old.
This design replaces both the propeller, nose cone and the shaft with a stronger design. It still wont survive a four year old but at least I can print replacements :D
Print the Nose cone vertically on its tip with a raft, 100% infill
The propeller may need a little sanding of the center hole depending on how well your print came out.
If you found this useful, please leave a comment!
Tips are not expected but always welcome.
Thanks, Enjoy!
Rafts:
Yes
Supports:
No
Resolution:
0.2
Infill:
100%